• Chevy/Jeep spindle bolt pattern accepts "outers" from all open knuckle Chevy and Jeep Dana 44, Dana 30, and 10-bolt front ends to 1986
• Cast from high strength ductile iron
• Beefed up with extra material and ribbing
• Flat tops machined and drilled for high steer arms
• 4th bolt hole for high steer arms increases clamping force and sheer strength
• 3 bolt high steer arms still fit
• 3/8" thickness added to flat top of the knuckle for high steer tie rod to leaf spring clearance
• Cast-in DUAL steering stops eliminate bent stop bolts that can cause u-joint and axle failures
• Tapered tie rod holes accept factory tie rod ends
• Tie rod holes can be drilled to accept 3/4" heim ends
• Powder coated bright orange for long lasting looks
• Interchangeable with all factory and aftermarket Dana 44 components
• Fully machined and ready for installation
• Machined to clear CTM u-joints without removing the grease fittings
• Tie rod hole is tapered from the top to the bottom

Will fit 10-bolt and early Dana 30 axles with minor modification.

Knuckles for off road use only.
There is no warranty on this product.